- This topic has 1 reply, 2 voices, and was last updated 7 years, 3 months ago by
.
Viewing 1 post (of 1 total)
-
Posts
-
Probably a bit late now, however if you refer to clause 4.5.5.4, it has the flattened circular hollow section listed for prequalified joints.
If your joint meets this criteria, all is good.
If it is “non-standard” as you say, determine the weld preparation & material grade to be used, and develop a procedure from this. The flattening of the tube does not form part of weld procedure.
Viewing 1 post (of 1 total)
- You must be logged in to reply to this topic.